You want about 600-750 gph for your 75 gallon tank for best efficiently. The 75 and 110 have the same mechanism.įor my 75 gallon tank I have a Sunsun canister 303B at 370 gph and a Tidal 75 at 350 gph. For Tidal 75 and 110, where the impeller goes that continuously flushes a little bit of water through the back to keep it cool and quite clean. There is a groove in the Tidal 55 that goes through the slot where the impeller stays and it will continuously clean the impeller of any debris or buildup. From Seachem Support: The self cleaning feature of the Tidal Filters can be explained by the structure and build of the impeller housing. Includes the best media, Seachem Matrix, that can harbor anaerobic bacteria needed to reduce Nitrates.Self priming w/submerged under water pump so it’s quiet and you never have to worry about it not starting or recovering from maintenance or a power failure, especially if you are not home.No need to turn the filter off either just remove the basket. Removable no spill media basket comes out for easy just cleaning using the lid as a no spill carrying tray.Media basket locks in place so it will never rise up pushing the media cage up possibly causing an overflow and flooding your floor.If the mechanical media at the lower portion of the media basket ever gets clogged it has a slightly higher bypass in the basket so the water will still be filtered through your media and continues to run efficiently.Another knob to totally shut off the bottom intake if you only want to filter the middle and top of your tank only.Draws water from three locations, top ( skimmer), middle and bottom for better water filtering, not just the bottom.Each notch is a 10% increase or decrease so you can manage your water flow to slow your water so it stays in contact with your media longer which is better for beneficial bacteria. A flow knob to control 80% of the water flow.The Seachem Tidal filters have these advantages over all other HOB filters. Twist this cover to the left to detach it, then pull to remove the impeller from its housing.I might suggest a Seachem Tidal Filters for just some of the following advantages: The impeller is locked in place by a final circular cover. Locate the top clip and gently pry it upward, pulling the cover away from the pump to remove. This is attached by two clips on the top and bottom of the pump. The Impeller is held inside the pump by an impeller cover. The pump should slide smoothly out of the filter when pushed gently to the right. Slide the pump to the right to detach it from the filter Slide it out of this channel so that you can remove the pump.Ĥ. The power cord is set into a channel on the side of the filter to keep it looking neat. Gently squeeze above the pump housing with one hand, grip the pump housing with the other hand, and pull downward to remove.ģ. You should never do maintenance on the filter while it is still plugged in. If your filter stops working or seems to have a reduced flow rate, it is a good sign that the impeller may need to be cleaned! Here is how to remove the impeller for cleaning or replacement. Impellers should be cleaned along with regular filter maintenance to keep your filter running smoothly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |